MOPAR A833 4-SPEED TRANSMISSION & COMPONENT SPECIALISTS

Foam axle retainer to backing plate gasket, all Dana 60 and 8 3/4 rearends, 2 required per car, sold each.

Metal axle housing to backing plate gasket, all Dana 60 and 8 3/4 rearends, 2 required per car, sold each.

Passenger's side rear axle locking pawl & nut, for all 1965 & up 8 3/4 and Dana 60 rear axles, holds the wheel bearing adjusting star in place after axle end play is set.

Lakewood axle shims 2 degree, pair. Mount between axle housing and leaf spring to correct pinion angle.

Lakewood axle shims 4 degree, pair. Mount between axle housing and leaf spring to correct pinion angle.

Inner axle seal, fits all 1965 to 1978 8 3/4 rear axle assemblies, 2.69" outside diameter, 1.50" inside diameter, two required per vehicle, sold each.

Outer wheel bearing seal (installs in retainer/adjuster plates), fits all 1965 to 1978 8 3/4 and 1966 to 1972 Dana 60 9 3/4 rear axle assemblies, two required per vehicle, sold each.

Inner axle seal, 2.502" outside diameter, 1.5" inside diameter, fits all 1966 to 1972 Dana 60 9 3/4 rear axle assemblies, two required per vehicle, sold each.

3.23 axle ratio tag. For all 8 3/4 rear axles.

3.54 axle ratio tag. For all Dana 60 rear axles.

3.55 axle ratio tag. For all 8 3/4 rear axles.

3.91 axle ratio tag. For all 8 3/4 rear axles.

4.10 axle ratio tag. For all Dana 60 & 8 3/4 rear axles.

"USE SURE GRIP LUBE" TAG, 8 3/4 ROUND ALUMINUM.

"USE LIMITED SLIP DIFF. LUBE ONLY" tag, DANA 60, for all 1966-1972 Dana 60 rear axles.

Replacement stud and nut package for Mopar 8 3/4" and Dana 60 axle housing, retains backing plate/axles, set of 10.

Replacement studs/nuts/washers for Mopar 8 3/4" housing/carrier, retains 3rd member, set of 10.

Re-useable differential housing gasket for all 8 3/4 rear ends.

Gasket and seal kit for 1965 and later 8 3/4 rear ends. Includes differential housing gasket, 2 inner axle seals, 2 foam axle gaskets, and 2 metal backing plate gaskets.

Differential gasket, all 9 3/4 Dana 60 rearends.