MOPAR A833 4-SPEED TRANSMISSION & COMPONENT SPECIALISTS

Battery tray, fits all 1965-73 C-bodies.

Battery tray, fits all 1973-4 B-bodies.

Lower battery tray brace for 1967-70 B-body cars, 2 required for 1967-69, 1 for 1970 cars, sold each.

Upper battery tray brace for 1966-69 B-body cars. One used per car.

Lower battery tray brace for 1966 B-body, E-body and 1971-72 B-body cars. 1966 B-body uses 2, later cars use 1. Sold each.

Lower battery tray brace, fits all 1967 to 1976 A-body applications

Battery tray brace set for 1967-69 B-body cars, all three braces included.

Clutch Alignment Tool 18 Spline, insures proper alignment of the clutch disc/pilot bushing when installing pressure plate. For all 1965 to 1972 440/Hemi 18 spline applications.

Clutch Alignment Tool 23 spline, insures proper alignment of the clutch disc/pilot bushing when installing pressure plate. For all 1964 to 1987 23 spline applications

Clutch Alignment Tool for 23 spline applications, insures proper alignment of the clutch disc/pilot bushing when installing pressure plate. For all 1964 to 1987 23 spline applications, made from original Mopar input shaft.

Replacement throwout bearing only for USA made 23 spline small sleeve collars, save some money if your collar is in good condition. Made in USA.

Throwout bearing/sleeve assembly, fits 1967-1972 440 powered models with 18 spline transmissions and 1970-71 426 Hemi 18 spline transmissions. 1.70" height from face of throwout bearing to clutch fork pads. WILL NOT fit 1966-1969 Hemi models with 172 tooth flywheel/direct drive starter! (See CB586 for bearing only for these cars). Made in USA.

Replacement throwout bearing/sleeve assembly, fits 1967-1972 440 powered models with 18 spline transmissions and 1970-71 426 Hemi 18 spline transmissions. 1.70" height from face of throwout bearing to clutch fork pads. WILL NOT fit 1966-1969 Hemi models with 172 tooth flywheel/direct drive starter! (See CB586 for bearing only for these cars).

Throwout bearing/sleeve assembly, fits all models with 23 spline transmissions. 1.625" face of throwout bearing to fork pad dimension. Made in USA.

Throwout bearing/sleeve assembly, fits all models with 23 spline transmissions. 1.625" face of throwout bearing to fork pad dimension. Import bearing.

1969-71 440 Six Pack Coil Strap Mounting Bracket. Accurately reproduced from the correct gauge material and with the correct 1/4-28UNF x 3/4" long mounting studs. Bracket comes complete with two NOS phosphated coni keps nuts as original.

1970 340 Six Pack Coil Strap Mounting Bracket. Accurately reproduced from the correct gauge material and with the correct 1/4-28UNF x 3/4" long mounting studs. Bracket comes complete with two NOS phosphated coni keps nuts as original.

Replacement throwout bearing only for all 18 spline large sleeve collars, including the shorter 1966-69 Hemi models with 172 tooth flywheel/direct drive starter. Money saver if your collar is in good condition. Made in USA.

Big Block/Max Wedge/Race Hemi/Street Hemi coil bracket, nice reproduction.

McLeod hydraulic hose, master cylinder to bearing, 24"